Restore Ubiquiti AirOS onto AirRouter. Check the IP settings to make it work.

Hello,
I have been able to restore AirOS onto my Bullet 2HP after Tanaza, however, I can not seem to get the Air Router to restore.
This is what I have done:
Change the IP address of the Air Router to 192.168.1.1 via Tanaza setup TCPIP panel
plug computer directly into the WAN ethernet jack of the Air Router. While router un plugged, I use a pin to depress the reset button, then plug the router in while button still depressed.
Once router lights show it is in recovery mode, I attempt to ping 192.168.1.1. i get no response.
When I boot the router normally, I am able to ping 192.168.1.1, however, it is not in TFTP mode.
Does anyone have any ideas?
1 person has
this problem
+1
Reply